What is ip route command for?

What is ip route command for?

What is ip route command for?

The ip route command is one of the many features of the newer ip utility. This command can be used to display or modify the existing IP routing table. We can add, delete, or modify specific static routes to specific hosts or networks using ip route command.

How do I set a static ip route in Linux?

Add a static route on Linux

  1. $ su – OR use the sudo as follows:
  2. $ sudo -i. Once become a root user, setup a temporary route using the ip command:
  3. # ip route add 172.10.1.0/24 via 10.0.0.100 dev eth0. Verify new routing table, enter:
  4. # ip r.
  5. # ip link set dev tun0 up mtu 1500.
  6. # ip r.

How do I use routing table in Linux?

Using netstat command Netstat combined with the -r option will display the kernel routing tables. This is commonly used with the -n option, which will only show numerical addresses rather than performing any sort of name resolution.

How do I assign an IP address to a route table?

Workaround 1: Manually add the default route for the Interface

  1. Click Start, click Run, type cmd in the Open box, and then click OK.
  2. Type route print, and then press ENTER to view the routing table.
  3. Type the following command, and then press ENTER route add 0.0.0.0 mask 0.0.0.0 gateway IP metric 30 if Interface number.

How do I enable IP routing?

About This Article

  1. Open the Registry Editor.
  2. Navigate to “HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\Services\Tcpip\Parameters.”
  3. Right-click “IP Enable Router” and click Modify.
  4. Change the “Value Data” field from “0” to “1.”
  5. Click Ok, close the Registry Editor, and restart your computer.

How do I create a permanent route in Centos 7?

To do this, you need to add a static route.

  1. Add a temporary static route. If you wish to add one temporarily, simply run the ip route add command with the right network information: ip route add 172.16.5.0/24 via 10.0.0.101 dev eth0.
  2. Add a permanent static route.
  3. If you lose your internet connection.

How do I add a static route?

Configuring Static Routes

  1. Navigate to the Configuration > Network > IP > IP Routes page.
  2. Click Add to add a static route to a destination network or host. Enter the destination IP address and network mask (255.255.
  3. Click Done to add the entry. Note that the route has not yet been added to the routing table.

How do route tables work?

A routing table contains the information necessary to forward a packet along the best path toward its destination. Each packet contains information about its origin and destination. Routing Table provides the device with instructions for sending the packet to the next hop on its route across the network.