How do you adjust a bus compressor?
How to Set a Mix Bus Compressor: In Detail
- Start with a slow attack (maybe 50-100ms) and fast release (maybe 0.2 to 1.0ms).
- Set your ratio to anywhere between 1.5:1 and 4:1.
- Ultimately, you’ll want to bring down the threshold so you’re that you’re compressing by anywhere from 1-4 dB during the loudest sections.
What compressor settings should I use?
Settings between 1.5:1 and 10:1 are the most common. A lower first number in your ratio will give you gentle compression you might apply to an entire mix, while a higher first number will give you an intense squashing effect.
Should mix bus compression be done in mixing or mastering?
Applying compression after the mix is complete thus risks changing the balance you have carefully set up, so unless you mixed into a compressor from the start, compressing the mix is best left to the mastering engineer.
What are compression settings?
Compression is used in music to reduce the dynamic range of signals with loud and quiet elements so that both can be heard clearly. Compression is used in music to reduce the dynamic range of signals with loud and quiet elements so that both can be heard clearly.
What is stereo bus compression?
Quick Answer. Bus Compression is the act of using a compressor on the master output to create a uniform sound for the entirety of a mix or master. Bus compression is often used in mixes and masters to create a cohesive and overarching timbre for the recording.
What should be on mix bus?
Mix bus processing is just a fancy word for fine-tuning your mix as a whole. Instead of adjusting individual tracks, you use tools like EQ, compression, and saturation on the whole mix. It’s kind of like pre-mastering. It’s the cherry on top of your ice cream sundae.
What is a good compression ratio for mastering?
Most mastering engineers use high thresholds and low ratios (typically 1.25:1 or 1.5:1 – rarely anything more than 2:1) in order to achieve just 1 or 2 dB of gain reduction.
How do you set a compressor?
Try starting with the compressor set to the fastest attack, fastest release, and highest ratio setting for the compressor. Then adjust the input volume or threshold setting until about 16-24 dB of the audio signal is reduced on average (also known as gain reduction).
How much compression is in a mix bus?
Mix bus compression gets added to the entire mix, so subtlety is the key here. You don’t want the compressor to act too aggressively. In general, a 2:1 ratio is enough. Sometimes, even a 2:1 is too much.
https://www.youtube.com/watch?v=N59xJcgs59M