How do I change my Canon printer to a new Wi-Fi?

Table of Contents

1. Change the printer settings

Make sure the printer is turned ON.
Select. Setup on the HOME screen of the printer operation panel.
Select. Settings.
Select. Device settings, LAN settings, then Wireless Direct.
Select Wireless Direct, then Wireless Direct active / inactive.
Select ON.
Select Yes.
Select OK.

How do I connect Canon mg3100 to Wi-Fi?

Step 1

Press and hold the [Maintenance] button (A) on the printer for approximately 5 seconds.
Press the [Fit to Page] button (A).
Make sure that the LED ﬂashes as shown in the illustration above, then press the [WPS] button on your access point within 2 minutes.

How do I change the Wi-Fi on my Canon G3000 printer?

Canon Pixma G3000 Connect to Wifi

Turn ON your Printer.
Now, press the button that shows the Wi-Fi signal, and hold this button till the light in the lamp flashes.
Now, click the colour button.
Click on the Wi-Fi button to continue with the canon pixma g3000 wifi setup.
Check the quick flashing of the Wi-Fi lamp.

How do I reset my network settings on my Canon printer?

Reset wireless network settings to default

Press the Setup. button.
until Device settings appears, then press OK.
until Reset setting appears, then press OK.
until LAN settings appears, then press OK.
Press the left arrow. to select Yes, then press OK.

Do I have to reconnect my printer after changing router?

If you aren’t interested in printing wirelessly, you don’t need to reconnect your printer after changing the router. You will, however, need a wired connection to use the printer in the future.

How do I connect my Canon Pixma printer to Wi-Fi?

Make sure that the printer is turned on. Press and hold the [Wi-Fi ] button on the top of the printer until the orange alarm lamp flashes once and then release it. Make sure that the Wi-Fi button starts to flash blue and then go to your access point and press the [WPS] button within 2 minutes.

Why will my Canon printer not connect to Wi-Fi?

If there have been no changes to your wireless network (new router, new password for your router, etc.), turn off and unplug your printer. Unplug your wireless router for 15 seconds, then plug it back in. After it has fully initialized, plug the printer back in and power it on. Try to print again.

How do I reconnect my printer after changing my router?

Use the Wi-Fi Protected Setup (WPS) button on your router to connect the printer to your Wi-Fi network.

Place the printer near the Wi-Fi router.
Put the printer in WPS connection mode.
Within two minutes, press and hold the WPS button on the router until the connection process begins.